+================================================
+                                                
+ DrufelCNC - Vectric machine output configuration file   
+                                                
+================================================
+                                                
+ History                                        
+                                                
+ Who    When       What                         
+ ======== ========== ===========================
+ DrufelCNC     10/04/2020 Written              
+================================================

POST_NAME = "DrufelCNC (mm) (*.tap)"

FILE_EXTENSION = "tap"

UNITS = "MM"

+------------------------------------------------
+    Line terminating characters                 
+------------------------------------------------

LINE_ENDING = "[13][10]"

+------------------------------------------------
+    Block numbering                             
+------------------------------------------------

LINE_NUMBER_START     = 0
LINE_NUMBER_INCREMENT = 10
LINE_NUMBER_MAXIMUM = 999999

+================================================
+                                                
+    Formating for variables                     
+                                                
+================================================

VAR LINE_NUMBER = [N|A|N|1.0]
VAR SPINDLE_SPEED = [S|A|S|1.0]
VAR FEED_RATE = [F|C|F|1.1]
VAR X_POSITION = [X|C|X|1.3]
VAR Y_POSITION = [Y|C|Y|1.3]
VAR Z_POSITION = [Z|C|Z|1.3]
VAR X_HOME_POSITION = [XH|A|X|1.3]
VAR Y_HOME_POSITION = [YH|A|Y|1.3]
VAR Z_HOME_POSITION = [ZH|A|Z|1.3]

+================================================
+                                                
+    Block definitions for toolpath output       
+                                                
+================================================

+---------------------------------------------------
+  Commands output at the start of the file
+---------------------------------------------------

begin HEADER

"(DrufelCNC from Vectric)"
"(Material Setup)"
"(X Min = [XMIN]   Y Min = [YMIN]  Z Min = [ZMIN])"
"(X Max = [XMAX]   Y Max = [YMAX]  Z Max = [ZMAX])"
"(X Length = [XLENGTH])"
"(Y Length = [YLENGTH])"
"(Z Length = [ZLENGTH])"
"G17"
"G21"
"G90"
"G0[ZH]"
"G0[XH][YH]"
"M3[S]"


+---------------------------------------------------
+  Commands output for rapid moves 
+---------------------------------------------------

begin RAPID_MOVE

"G0[X][Y][Z]"


+---------------------------------------------------
+  Commands output for the first feed rate move
+---------------------------------------------------

begin FIRST_FEED_MOVE

"G1[X][Y][Z][F]"


+---------------------------------------------------
+  Commands output for feed rate moves
+---------------------------------------------------

begin FEED_MOVE

"[X][Y][Z]"


+---------------------------------------------------
+  Commands output at the end of the file
+---------------------------------------------------

begin FOOTER

"G0[ZH]"
"M05"
"G0[XH][YH]"
"M09"
"M30"